Clean GU Boot Bell
2) Install Rubber Boot Connector (per manufacturer's instructions).
Wedge style expander
bolts must be aligned with "top"
of GU Boot Bell.
3) Pre-miter pipe end be as required to predetermined pipe
deflection angle. Merely "DE-BURR" pipe end - DO NOT
CHAMFER OR BEVEL PIPE END
spigot; orient pipe miter; slide into Rubber Boot Connector; "home"
pipe to GU Base Liner channel end; deflect pipe as required. Inspect
manhole base interior for channel / pipe invert alignment and
seal; tighten rubber boot pope clamp (per manufacturer's instructions).
Secure and back fill with proper material as specified. (NOTE:
ALL STUBS AWAITING PIPE INSTALLATION AT A LATER DATE MUST BE RESTRAINED)
5) Check for watertight connection; test in approved method.
The Rubber Boot Connector is mounted in an integrally cast-in-place
GU BOOT BELL assembly which is
monolithically bonded to the interior manhole liner and extends
to the exterior profile of the precast concrete manhole. The monolithic,
continuous bell sleeve liner assembly prevents ground water infiltration
between the interface of the manhole liner and the precast concrete
or around cast-in-concrete mounted connector not in continuous
bell sleeve assemblies.