REHAB LINER
SUPPLY SOURCES (01/07)

Polypropylene (PP) REHAB LINER
GROUT, BONDING ADHESIVE AND ELASTOMERIC SEALANTS

THE FOLLOWING IS PRODUCT SOURCE INFORMATION FOR THE RECOMMENDED “GROUT” AND ADHESIVE / SEALANTS REQUIRED FOR INSTALLATION OF THE Polypropylene (PP) REHAB LINER.

PUMPABLE BONDING GROUT & APPROVED APPLICATION SPECIALISTS

  PRODUCT: MASTER BUILDERS' "CONSTRUCTION GROUT"
  Master Builders, Inc.
23700 Chagrin Blvd.
Cleveland, OH 44122-5554
TEL: 800 / 628-9990
FAX: 216 / 831-6910
www.masterbuilders.com

  PRODUCT: EUCLID CHEMICAL'S "N.S. GROUT"
  The Euclid Chemical Co., Inc.
19218 Redwood Road
Euclid, Ohio 44110
TEL: 800 / 321-7628
www.euclidchemical.com

PRODUCT: BUTYL RUBBER PREFORMED FLEXIBLE JOINT SEALANT
(PRECAST CONCRETE TOP SECTION JOINT ONLY - CONE / FLAT TOP / CAST IRON FRAME)
(SPECIFICATION - ASTM C-990, Section 6.2 Butyl Rubber Sealant

Henry Company, Sealants Division
1277 Boyles St.
Houston, TX 77020
TEL: 713 /671-2494 - 800 / 231-4549
FAX: 713 / 673-7714
PRODUCT: RUB’ R-NEK “LTM
Press-Seal Gasket Corporation
2424 W. State Blvd.
Fort Wayne, IN 46804
TEL: 219 / 436-0521 - 800 / 348-7325
FAX: 219 / 436-1908
PRODUCT: PRO-STIK or CPS-210

ELASTOMERIC SEALANTS - RESILIENT CURING NON SHRINK CAULK TYPE (MECHANICAL ANCHOR PENETRATIONS AND REMEDIAL “CAULK” SEAL OF MISCELLANEOUS JOINTS OR SEAMS - 1” WIDTH OR LESS)
NOTE: The sealant manufacturer’s application and surface preparation procedures (including primer) must be followed. This includes recommended maximum joint depth of 1/2” (1/4” minimum thickness) and the use of bond-breaker polyethylene closed cell foam backer rod or polyethylene bond breaker tape.

SIKA Corporation
201 Polito Ave.
Lyndhurst, NJ 07071
TEL: 800 / 933-7452
PRODUCT: SIKAFLEX 1a
Polyurethane sealant;
Use SIKAFLEX 449-203 Primer

General Electric Company
260 Hudson River Road
Waterford, NY 12188
TEL: 800 / 255-8886
PRODUCT: GE CONTRACTORS SCS 1003
Silicone sealant;
Use GE SS4179 Primer
Tremco, Incorporated
3735 Green Road
Beachwood, OH 44122
TEL: 800 / 852-8173
PRODUCT: VULKEM 921
Polyurethane Sealant;
Use Tremco171 Primer (porous substrates)
Use Tremco181 Primer (metal substrates)